碳硫高速分析儀操作[英文]

TL-CS型碳硫高速分析儀操作

Carbon & sulfur high speed analysis meter operation （Model:TL-CS）

一、打開所有電源和前氧，再開氧氣（壓力控制在0.02—0.04Mpa ）zui后關前氧。

1. Turn on all power supply and frontal oxygen switch,then open the oxygen（the pressure limitation is 0.02—0.04Mpa）shut down the frontal oxygen switch finally.

二、依次加入硅鉬粉小半藥匙左右,錫粒少量,樣件（所有普碳鋼、低合金銅樣件量為1G，分析天平稱量）到銅坩鍋內。

2.   Put half spoon of silicon molybdenum powder in turn,a little tin grain and metal sample（the quantity of carbon steel and low alloy copper sample is 1G, analytical balance quantify）into copper crucible.

三、按信對零下放，使量氣筒液面降到底，調“碳調零”，顯示“0”。

3.  Put down switch to the zero scale, lower down liquid level to the bottom of air measuring cylinder, adjust the button“ Carbon to the zero” to the scale“0”.

四、點一下準備，待量氣筒、滴定管液面加滿調“硫調零”，顯示“0.000”zui后一位千分位可以不為0.

4. Touch the switch preparation, after topping up air measuring cylinder and buret, adjust the button“Sulfur to the zero”to the “0.000”the last number could not be 0.

五、升起升降軸，先開后控再開前氧（控制流量為80-1200）.

5.  Rise up the lifting shaft, Turn on, adjust and Turn on frontal oxygen again（adjusted flow area 80-1200）

六、點一下分析后，看集氣瓶液面回到原位，后關前氧看D4燈滅時顯示數值。（*定標：待D4燈滅即點一下復位，分別調“C”、“S”標準使顯示標樣數值）。

6.Touch the analysis switch, when the liquid level of gas collecting bottle is back to original place shut down the frontal oxygen switch and read the number of D4 light when it is off（Read standard data:touch the reposition, adjust “C”、“S” and read standard data.

七、關后控，降下升降軸。

7. turn off back controller,lower down the lifting shaft.

八、關電源與氧氣。

8. Shut down the power supply and oxygen.

注：黑體字表示機器按鈕或操作手柄。

Note: Overstriking words show the button of machine or operation handle.

                                                                                           南京天量分析儀器有限公司

                                                                      2011   03